Unisub Sublimation Round Ornament Blanks - 2.75" - 4599

Imprint your DIY ornaments for Christmas, home decor, gifts, home-based business and more. Available in gloss finish. Made from Aluminum. Include include a red or white satin ribbon for hanging. Heat transfer vinyl (HTV) can also be applied to these sublimation blanks. 

Download free sublimation template


  • DIAMETER : 2.75" (69.8mm)
  • SUBSTRATE : Aluminum
  • THICKNESS : 0.045" / 1.14mm
  • COATING : White
  • FINISH : Semi-Gloss

Volume Pricing 

  • Pack of 1 Ornament           $1.25 / Ornament
  • Pack of 10 Ornaments         $1.20 / Ornament
  • Pack of 20 Ornaments        $1.18 / Ornament
  • Pack of 50 Ornaments         $1.14 / Ornament

How to Sublimate Aluminum Ornament Blank

Materials needed

  • Unisub Aluminum Ornament Blank
  • Sublimation Printer
  • Heat Press
  • Heat Tape
  • Cleaning Cloth
  • Blowout Paper
  • Printed Transfer
  • Printing RIP Software
  • Heat Gloves
  • Scissors
  • All-Purpose Cleaning Fluid

Step-By-Step Guide

    1. Turn on your heat press. Set the temperature to 400°F / 205°C (temperatures based on prints made with small desktop sublimation printers). Strong pressure is recommended. (settings may vary based on equipment). Add a sheet of protection paper (blowout paper) on the bottom plate of the heat press.
    2. Clean the surface with all-purpose cleaner, a cloth, and compressed airYou should have two images printed on your transfer paper. Cut the corners of one of the transfers about 5 mm away from the edge of the image in order to have plenty of space to tape the first transfer to the second.
    3. Next, line up and center one side of the blank ornament to the transfer with the cut corners. Pick up the ornament and crease the transfer paper along the edges of the ornament so it will stay lined up with the outline of the image or graphic. Make sure the transfer is at the edge of the table, and hold the first transfer in place by tightly gripping the ornament and transfer with your thumb and finger. 
    4. Line it up with the second transfer, keeping the first side of the transfer slightly peeled back, so you can see where you’re placing  the ornament. 
    5. Once secured on the second transfer, peel back the edges of the first transfer to double check that all the sides are even. Make small adjustments as needed.
    6. Next, place four pieces of tape on the corners to secure the transfers to the ornament. Avoid placing the tape on the ornament outline. Carefully slide the prepared ornament off the table and place in the heat press. 
    7. Add everything in the center of the bottom plate of the heat press. Be sure that your printed transfer is face-down on the bottom plate. Add a layer of blowout paper or Endura on top of your printed transfer. Set the correct temperature & time (see below) Close the heat press so the sublimation process starts.
    8. When the sublimation process stops, remove immediately the transfer paper off both sides of the ornaments and allow the product to cool down. 

Attention: the item will be hot, so wear protective heat gloves.



Both Side at a Time

One Side at a Time

Two-Sided Aluminum



One-Sided Aluminum



45 seconds

*The stated sublimation times are only valid for prints made on small desktop sublimation printers.

    Extra tip for One-sided Ornaments - To press a one-sided ornament, simply place the blank ornament on the transfer. Place in the heat press for 1:00 to 1:05 mins.

    Related Items