Unisub Sublimation Blank Plaque 8" x 10" - 1003

Recognition deserves attention – create lasting memories of achievements with full color plaques available in a variety of sizes and shapes.

Specification

  • SIZE  8" x 10"  (203.2mm x 254mm)
  • SUBSTRATE : MDF
  • THICKNESS: 0.625" / 15.875mm
  • FINISH : Gloss
  • COATING: White
  • Keyholes for both portrait and landscape orientations
  • Black Ogee Edge

Volume Pricing 

  • Pack of 7 Blanks           $7.00 / Blank
  • Pack of 14 Blanks           $7.15 / Blank
  • Pack of 21 Blanks         $7.43 / Blank

Materials needed

Step-By-Step Guide

  1. Turn on your heat press. Set the temperature to 385°F (temperatures based on prints made with small desktop sublimation printers). Strong pressure is recommended. (settings may vary based on equipment). Add a sheet of protection paper (blowout paper) on the bottom plate of the heat press.
  2. Remove film. Make sure to gently scrape perpendicular to where the sides meet the surface once you peel the film to get remove any excess foil or material. Clean the product line up and center the plaque to the transfer, paying attention to keyhole placement. If the plaque has an ogee edge, be sure to look closely at the plaque where it meets the transfer to make sure they align.
  3. Flip the plaque and transfer over, and crease the edges to make sure the bleed lines up. Tape edges of the transfer to the back of the product. With bare side facing up, press between two sheets of blowout paper at 385° F for 1:05-1:10. Time may vary based on equipment.
  4. Remove transfer, allow to cool, and hang to display.

    Attention: the item will be hot, so wear protective heat gloves. Increase time if pressing more than one clock at a time.

Product

Temperature

Time (min)

Plaque

385°F

1:05-1:10

*The stated sublimation times are only valid for prints made on small desktop sublimation printers.

INSTRUCTIONS


      Related Items